If the remote control or remote activation device is not working with your PULSE 100 Series door operator,
consider the following troubleshooting actions:
- Check that the remote receiver is activating when the remote is pressed.
- Check that the remote receiver is using normally open contacts for OPEN/CLOSE.
- Check that the wires are making good contact with the terminals on the remote receiver and on the operator.
For further details refer to the installation manual .
If the remote control or remote activation device is not working with your PULSE 200 Series door operator,
consider the following troubleshooting actions:
- Check that the remote receiver is activating when the remote is pressed.
- Check that the remote receiver is using normally open contacts for OPEN/CLOSE.
- Check that the wires are making good contact with the terminals on the remote receiver and on the operator.
For further details refer to the installation manual .
If the remote control or remote activation device is not working with your PULSE 500 Series door operator,
then check the wiring of the remote control or remote activation device.
The remote radio input requires the receiver to make a momentary dry contact between terminals 1 and 2 on the control board.
The remote radio input requires the receiver to make a momentary dry contact between terminals 1 and 2 on the control board.
The PULSE 500 Series door operator will work with any universal receiver
that can make a momentary dry contact between two terminals:
For single button operation:
- Only a single normally open channel is required
For 3 button operation:
- 3 channels will be required:
- 2 channels with normally open contacts for OPEN and CLOSE
- A third channel with normally closed contact for STOP.
