1. Support Home
  2. PULSE 500 Series
  3. Encoder
  4. Door Operator Stuck in Loop to Reset Encoder

Door Operator Stuck in Loop to Reset Encoder

For your PULSE 500 Series door operator, if the door is stuck in a loop where it keeps asking to reset the encoder, opens up, hits the hard-stop bracket, and then asks to reset the encoder again, try factory resetting the door operator from the Advanced Menu.
After that, redo the voltage settings and door limits.

Related Articles

How to Check If Encoder Is Installed and Works Properly "Check Encoder" Message on LCD Screen Door Operator Stuck in Loop to Reset Encoder How to Check Encoder Gain

Leave feedback on this article







Need more assistance?

  Click to Chat Now

Still can’t find the information you need?


By clicking “Allow All Cookies”, you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts. For more information please refer to our Privacy Notice.

iControls Inc. Logo

Privacy Preference Center

When you visit iControls.ca, we may store or retrieve information on your browser, mostly in the form of cookies. This information might be about you, your preferences or your device and is mostly used to make the site work as you expect it to. The information does not usually directly identify you, but it can give you a more personalized web experience. Because we respect your right to privacy, you can choose not to allow some types of cookies. Click on the different consent preferences below to find out more. As a reminder, blocking some types of cookies may impact your browsing experience on iControls.ca.

For more information, please refer to our Privacy Notice .

Manage Consent Preferences