1. Support Home
  2. PULSE 500 Series
  3. Power
  4. Door Operator Flickers On and Off

Door Operator Flickers On and Off

If your PULSE 500 Series door operator flickers on and off, follow these steps:
  • Ensure that the V+, GM, GS, and COM cables are correctly connected in the junction box and control board.
  • Also make sure that V+, GM, and GS are approximately +24V DC when measured against COM.
  • Additionally, disconnect all peripheral devices such as photo-eyes, activators, door locks, or interlocks, as they could be shorting the control board.
  • If none of these steps work, please contact technical support for further assistance.

Related Articles

No Power in the Unit Operator AC Voltage Selection

Leave feedback on this article







Need more assistance?

  Click to Chat Now

Still can’t find the information you need?


By clicking “Allow All Cookies”, you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts. For more information please refer to our Privacy Notice.

iControls Inc. Logo

Privacy Preference Center

When you visit iControls.ca, we may store or retrieve information on your browser, mostly in the form of cookies. This information might be about you, your preferences or your device and is mostly used to make the site work as you expect it to. The information does not usually directly identify you, but it can give you a more personalized web experience. Because we respect your right to privacy, you can choose not to allow some types of cookies. Click on the different consent preferences below to find out more. As a reminder, blocking some types of cookies may impact your browsing experience on iControls.ca.

For more information, please refer to our Privacy Notice .

Manage Consent Preferences