Connected Photo-Eye Not Working

If the photo-eye is connected and not working with your PULSE 100 Series door operator, then check the input polarity setting switches on the board and set them as follows:
  • For an NPN type transistor, set the switch labeled '1' to ON and the switch labeled '2' to OFF.
  • If instead, you are using a PNP type transistor, then set the switch labeled '1' to OFF and the switch labeled '2' to ON.

Related Articles

Leave feedback on this article








Need more assistance?

  Click to Chat Now

Still can’t find the information you need?


By clicking “Allow All Cookies”, you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts. For more information please refer to our Privacy Notice.

iControls Inc. Logo

Privacy Preference Center

When you visit iControls.ca, we may store or retrieve information on your browser, mostly in the form of cookies. This information might be about you, your preferences or your device and is mostly used to make the site work as you expect it to. The information does not usually directly identify you, but it can give you a more personalized web experience. Because we respect your right to privacy, you can choose not to allow some types of cookies. Click on the different consent preferences below to find out more. As a reminder, blocking some types of cookies may impact your browsing experience on iControls.ca.

For more information, please refer to our Privacy Notice .

Manage Consent Preferences